What is a duct rodder ? Wire threaders are also known as piercers, pipe threaders, cable piercers, and more. There are also many types of threaders. The threaders can be divided into three parts: a copper core, a glass fiber-reinforced threading layer, and a high-voltage, low-density polyethylene protective layer. The biggest feature of the threader is that its tensile strength is very high, its bending performance is also very good, and it also has very good anti-oxidation properties.
Fiberglass rodder rental, also known as a fiberglass fiber reinforced plastic perforator, fiberglass fiber reinforced plastic threader, perforator, pipe threader, cable pipe threader, or cable perforator, is an excellent auxiliary tool for pulling guide ropes in pipelines. The smooth and flexible surface of the bookmarker maneuvers through narrow passages with ease. The bookmarker is composed of three parts: a copper core, a fiberglass reinforcement layer, and a high-low-density polyethylene protective layer (smooth, reinforced, and resistant to AIDS environments). The copper core extension allows the barring to be easily positioned in different ways.

How to Use the Cobra Duct Rod

The wire threader is a convenient tool. Its appearance has greatly facilitated the circuit decoration of indoor decoration, especially the decoration of hidden wires. In addition, the wire threader itself is low-cost and simple to make, and has become an essential tool for circuit workers.
The wire threader is a convenient tool. Its appearance has greatly facilitated the circuit decoration of indoor decoration, especially the decoration of hidden wires. In addition, the wire threader itself is low-cost and simple to make, and has become an essential tool for circuit workers.
Fortunately, with the simple tool of wire threader, wires, network cables, cables, and video cables can be easily threaded with very high efficiency. Since it is a concealed line, we must first lay the wire lines before threading them. The wire lines here are laid in pipes, and the wiring work we are about to perform next will also be carried out in these pipes. It should be emphasized here that a special pipe bender must be used to bend the bends of the pipe. Otherwise, it will be difficult for the wires to pass through.
After all the preparations are completed, you can use the conduit rodder to thread the needle. First, thread the rope at one end of the threader into the wiring tube, and then pull out the wire rope at the other end of the wiring tube. During this process, it is necessary to ensure that the rope is unimpeded throughout the wiring tube and cannot be bent in the wiring tube to avoid difficulty in threading the wire.
Cut off about five centimeters from both ends of the wire that needs to be threaded, and then wrap one end of the wire around the small coil at the end of the connector. If you need to connect several wires to a wiring tube at the same time, you can wrap these wires together, secure them together with tape, and wind them together on a small coil. Then, two people need to grasp the two ends of the threader, respectively. One person pulls the rope head on the threader hard at one end, and the other person slowly turns the small coil and slowly feeds the wire on the small coil into the wiring tube. , so that one end is pulled and one section is sent. The wires can be threaded in no time. If the wire is stuck during this process, you need to tap the wire tube until it becomes loose and then continue to pull it loose.

BILO-A Professional Cable Equipment and Construction Tools Manufacturer for You

The emergence of high-quality cable equipment and construction tools comes from professional manufacturers.BILO has focused on equipment and construction tools production for many years, accumulated rich industry experience and gained excellent reputation. If you choose BILO, you will find a reliable supplier in China.