1.Duct rodder story

 As we all know, science and technology are always moving in the direction of facilitating human life and production, because technology and innovation always based on serve humans. During the installation and overhaul of the circuit, the workers are always faced with complicated threading work, which is both troublesome and prone to errors. The workers are in great trouble. Finally, the fiberglass duct rodder born, which greatly reduced the difficulty of workers' threading work.

♦  Fiberglass duct rodder is a convenient tool, and its appearance makes the interior decoration of the circuit installation, especially the installation of the hidden line, has been greatly facilitated. In addition, the fiberglass duct rodder itself has a low cost and is simple to manufacture, and has become an essential tool for Electrical linesworker.

  ♦  The fiberglass duct rodder is mainly used for sewer pipes, traction guide ropes, cable wires and the like in wall pipes.

  ♦  The duct rodder was mainly used for the traction of the wall at the earliest time, and later developed into the sewer's optical cable and the traction of the line. The cable duct rodder has the advantages of saving time, saving labor, improving work efficiency, etc. It can be used for telecommunication pipeline cleaning and laying of optical cables, cables and plastic sub-pipes. When it is used, the fiberglass mandrel shall be led out from the guide wheel first, then be connected with the corresponding metal head and penetrate into the pipe. When used for cleaning, the guide head can drive the cleaning tool to clean the pipeline; when laying the cable, it can be brought into the steel wire or iron wire first, and then the steel wire or the wire traction cable can be used to enter the tube.Sometimes it is broken. We need duct rodder accessories to replace.

Fiberglass Cable Duct Rodder

2.How to use the fiberglass duct rodder steps

♦  First, When installing the dark line, before the threading, lay out a reasonable direction of the wire line pipe, the elbow is best to bend with the bender, fixed line pipe and we will also carry out the next stringing work In the pipeline. One point to emphasize here is that at the bend of the pipe, a special pipe bender should be used to bend it; otherwise, it would be difficult for the wire to pass through here.

  ♦  Second, Until all preparations are completed, the fiberglass duct rodder can be used to thread. First thread the of one end of the rod into the wire tube, then pull the wire rope at the other end of the duct rodder. In this project, it is necessary to ensure that the rope is unobstructed in the wire tube and that it cannot be bent in the wire tube, to fear that it is difficult to carry out threading work in the following.

  ♦  Subtract about five centimeters from the two ends of the wire to be threaded, and then wrap one end of the wire around the small coil at the end of the wire. If you need to insert several wires at the same time in a fiber, you can wrap the wires together, tape them together, and wrap them together around a small coil.

 ♦  Finally, two people need to seize the two ends of the fiberglass duct rodder, one person at one end should grab the head of the duct rodder above the threader tightly, and the other will slowly turn the fiberglass rod roll, the wire rod slowly on the duct rodder into the wiring In the tube, one end is pulled, one end is sent, and the duct rod can be quickly put on. If the fiberglass rod is stuck during this process, you need to beat the duct rod, loose it, and continue to pull it loose